3015 TOWERS UPPER SECTION 2,5m 180 SE w/wire ring
Artikelnummer:
12-43-0002
  • Hersteller:
    TELEVES
  • Barcode:
    7724438030158
  • Verpackungseinheit:
    1
  • Nettogewicht:
    7.9 kg
  • Bruttogewicht:
    7.95 kg
  • Hochgeladen am:
    01-11-2017
  • Das Produkt wurde entfernt:
    25-01-2024

Product description:

TELEVES towers and tower accessories are made of zinced steel and bi-chrome coating and they are supplied in two types of finishing (RPR or poliester painting). They can be installed at heights from 1 to 50,5 m. Depending on the model, they implement turned or plugged raccors (SE finishing) for its union.

Fixing the lower section to the base in the proper vertical position, and then mounting the consecutive intermediate sections, which will be fixed with the corresponding guy-wire; the assembly is carried out by climbing the already placed sections and raising subsequently the section to be placed, using for it the adequate elevating tools. The climbing has to be made with the appropiate safety conditions (safety-belt, anchoring, etc.); there won’t be more than two sections without shoring up. In case of coinciding two sections without guy-wire, auxiliary guy-wire will be used for the bracing of the sections during the set-up. The tower will be balanced adjusting the tension of the guy-wire and the using of proper balance-appliances.

First assembling the tower over the ground and raising it, once mounted, by means of a crane. This system can be used only with towers of heights lower than 18 meters in the model 180 and heights lower than 26 meters in the model 360.

Safety
If the installation of the tower is made on the roof, flat roof or other place of a building, the installer will take the necessary measures according to the indications of the architect responsible of the building, in order to know the mechanical resistance of these zones.

WARNING:

Trestle-tower installations should only be calculated and constructed by specialised professionals as these fall under their responsibility; the mounting instructions provided in this technical sheet are intended for information only, and the data given does not, in any way, affect the responsibility of the manufacturer who only guarantees his own products, provided that they are used under normal conditions. It will be necessary to conduct a project to install the tower for each specific site, which should take into account both the individual stresses and the recalculation of foundations in accordance with the relevant geotechnical study. The towers will be assembled by competent personnel and skilled in climbing, using all means of protection required to safeguard the security in vertical works. Remenber that international legislation requires for any structure higher than 3m a climber safety device. The use of Televes tower sections with non-Televes products may cause tower failure and even personal injury. Televes and Edision are not responsible of the misuse of these products.

Technical features:

- Transversal stainless steel rods mm 6
- Max. height with mast 3m: 7,5 m

Possible configurations:
Base + upper 1,25 + 3m mast = 3,75m total. No wires needed.
Base + upper 2,5 + 3m mast = 5m total. No wires needed.
Base + middle 2,5 + upper 1,25m + 3m mast = 6.25m total. A line of guy wires highly recommended, from the top of the upper section (3 lines @120?).
Base + middle 2,5 + upper 2.5m + 3m mast = 7,5m total. A line of guy wires highly recommended, from the top of the upper section (3 lines @120?).
Note that 0,5 m of the 3m mast will be inside the tower upper section. Therefore, a 3m mast means a height of 2,5m.

Payment Icons
development by www.netwerk.gr
close
loading...